Reloader's Nest Forum
Reloader's Nest Forum
Home | Profile | Active Topics | Members | Private Messages | Search | FAQ
 All Forums
 Reloading General
 General forum
 reloading the .17 remington

Note: You must be registered in order to post a reply.

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
Stan Posted - Jul 01 2017 : 22:01:14
I am beginning to load for this rifle. Does anybody know if there is a funnel made which is small enough to use to direct the powder into the case? My reloading funnels are too large.
15   L A T E S T    R E P L I E S    (Newest First)
Stan Posted - Jul 23 2017 : 10:34:18
I agree!
ethmoid1999 Posted - Jul 14 2017 : 08:11:57
I don't know. I use and used the book Bolt Action Rifles by Frank DeHaas and the directions outlined by him. I know a lot of people replace the trigger with a Timney trigger or another adjustable trigger. I do not adjust as low as you suggest. For safety's sake I'd suggest you get a smith to do it or even to install a new trigger. Safety is the main goal.
Stan Posted - Jul 14 2017 : 06:27:08
I usually shoot the model 70 Winchester. I will adjust that trigger to 2 1/4 lbs because of the safety mechanism. I was not sure if I could take the Remington trigger that low. Your thoughts?
ethmoid1999 Posted - Jul 13 2017 : 17:20:11
That's too heavy for most precision shooting people. It may be a good indication that the previous owner didn't shoot enough to wear anything out. Most prairie dog shooters would have adjusted the trigger or replaced it.
Stan Posted - Jul 12 2017 : 21:22:37
The trigger is currently being adjusted. I would like it around three pounds. I'd bet it is around five or six now!
ethmoid1999 Posted - Jul 12 2017 : 09:06:38
Stan, might also check the trigger pull. I've adjusted all my Remington 700's. Throat could be shot out but my first place to look would be copper fouling. Might check and see if there is data for loading the 17 with CFE223. It will limit copper fouling and some say even remove some. It has worked good for me in 223.
Stan Posted - Jul 12 2017 : 05:44:10
Ok.. I bought the rifle used. I will check it out. I cleaned it very well every ten shots.
ethmoid1999 Posted - Jul 11 2017 : 22:46:57
Did you buy this rifle new? If used, you might consider copper fouling. Somework but it can be removed. The one I had shot five shots under a dime.
Stan Posted - Jul 11 2017 : 21:25:09
Thanks. I will look at those powders. I have read that this rifle is accurate up to 300 yards. With a 20 or 25 grain bullet I am beginning to wonder. At 100 yards my Remington seemed to spray the bullets around somewhat using factory loads. Shot tighter groups at fifty yards by far. Very little wind too. Am looking at 25 grains now.
Zero333 Posted - Jul 08 2017 : 19:53:31
Benchmark
H-4895
H-335
IMR-8208
IMR-3031
AR-comp
RL-12

ethmoid1999 Posted - Jul 08 2017 : 18:31:27
Stan, been a long time since I loaded for one. Pretty sure I used IMR4198. I had Remington cases and used Remington 71/2 primers. Probably some easier metering and perhaps better powders now to obtain more velocity.
Stan Posted - Jul 08 2017 : 09:30:53
I have a .17 Remington in the model 700 Remington. Does anyone have any load data that shoots well. I have nosler 20 grain and hornady 25 grain v-max bullets to use in it.
Leatherstocking Posted - Jul 02 2017 : 09:06:34
I have an RCBS in .17, which I use for .204R.

http://www.sinclairintl.com/reloading-equipment/powder-handling/powder-funnels/powder-funnels-prod54181.aspx?cm_sp=Secondary+Banner-_-Reloading+Equipment-_-Shop_Reloading_Equipment
ethmoid1999 Posted - Jul 02 2017 : 08:56:21
Loaded for one maybe forty years ago. Tiny powder funnels and tiny cleaning rods and jags and patches. It was a fun cartridge.
Stan Posted - Jul 02 2017 : 07:18:45
Thanks! Got it.

Reloader's Nest Forum © 2016 ReloadersNest Go To Top Of Page
This page was generated in 0.09 seconds. Powered By: Snitz Forums 2000 Version 3.4.06