Reloader's Nest Forum
Reloader's Nest Forum
Home | Profile | Active Topics | Members | Private Messages | Search | FAQ
 All Forums
 Reloading General
 General forum
 Hell of a time....

Note: You must be registered in order to post a reply.

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
Shoots High Posted - Jan 06 2017 : 18:16:54
I have been trying to adjust a .45 acp roll crimp die. I am loading for a 1911. I need to get it to close up about .002 more to get a good fit in my chamber, but all I can seem to do is crush a case. After about 50 rnds. I am going to give up and buy a taper crimp die. I got these carbide rcbs dies for a very good price, but it's not a bargain if I can't get them to work right. I have tried every trick I know of, even adjusting off of a loaded factory round, and spending 45 minutes with the rcbs guy on the phone (very helpful guy by the way).
I can make a roll crimp work for a M1 carbine, but for some reason not a .45 acp. What am I doing wrong?
3   L A T E S T    R E P L I E S    (Newest First)
WonderMan4 Posted - Jan 07 2017 : 13:24:30
I noticed that you changed your post to be a little kinder. Good for you.

A roll crimp is almost always unsuccessful with the 45 ACP when shot in semi-autos.

What happens is the firing pin will drive the cartridge deeper into the chamber than it needs to be thus creating some fail to fire situations.

With a taper crimp, the rim of the case seats on the chamber edge and prevents this movement.

You asked why the RCBS Tech was so willing to assist you. I am not sure why. Almost anyone with some knowledge would know that you needed a taper crimp die.

Why do they sell them? Maybe for use in revolvers that use "moon" clips to hold the cartridge at the rim. I always wondered why they sell 44 Mag dies with a taper crimp die in the set, but they do.
Shoots High Posted - Jan 07 2017 : 10:26:25
Although not ideal they can be used successfully. I will take your advice though and get back to basics. Thanks
Shastaboat Posted - Jan 06 2017 : 20:52:44
45 acp is a taper crimp case design. NO ROLL CRIMP. .30 Cal carbine is also not a roll crimp design case. Go back to basics and learn the difference in a roll crimp, rimmed pistol case and a taper crimp rimless design case.

Reloader's Nest Forum © 2016 ReloadersNest Go To Top Of Page
This page was generated in 0.03 seconds. Powered By: Snitz Forums 2000 Version 3.4.06